ENDUIT AIRLESS DGSOGENERAL INFORMATION • Roughing Render for Vertical Surfaces • Airless Spray or Rotor / Stator Flat Jet machine • Smooth, matt rendering • Odourless • Clean all equipment with waterORECOMMENDED USES • Enduit Airless DGS roughing render is ideal for smoothing concrete slabs, shuttered concrete and aerated concrete, for renovating stipple finishes or old damaged surfaces, and for preparing brick, brick tile or cement block surfaces. Surfaces must be clean, dry and sound (6 - 16% humidity). OAdvantages • Excellent filling capacity • Can be applied partially in thick layers • Easy to smooth and rework while setting ^APPLICATION • Enduit Airless DGS render is sprayed using an Airless Pump or the Flat Jet Rotor / Stator machine in two coats: • The first coat must be smoothed using a 60 cm trowel or flattened with a feather edge. • After drying, the second coat must be smoothed with a float. • After a short setting time, compact the render using a clean trowel and a narrow angle. • Ideal tips are 641 and higher, depending on the machine power. • Spray at around 60 cm from the surface. Do not use a filter. • It is advisable to use protective eyewear when spraying to prevent small particles getting into the eyes. • Surfaces should be dry, clean and sound. OCOVERAGE: 2 to 4 kg/m2 for the first coat, 1.5 to 2 kg/m2 for the second coat. ODRYING TIME: 12 to 48 hours depending on the temperature, humidity and ventilation of the room. OPACKAGING: 25 kg Bag or Container. OSHELF LIFE: 18 months in unopened container. Keep from freezing.